My Robot Store

My Robot Store
This is my robot store! Click on picture above for more information

Monday, September 3, 2012

OP Brackets printed out on a 3-D printer!

IMG_6051IMG_6050IMG_6049IMG_6048

OP Brackets, a set on Flickr.

This is all of the brackets needed to build the DARwIn-OP plus servo horns for the MX-28Ts!

IMG_6048
at

3 comments:

  1. UnknownJuly 22, 2013 at 6:18 PM

    Hi Mike, What is your preferred 3d printer...MAKE stated Up printer while alternately REPRAP? Also is this the best bloodspot? Thanks-a newbie!

    ReplyDelete
  2. UnknownJuly 22, 2013 at 6:20 PM

    Also Congratulations - very cool!

    ReplyDelete
  3. Michael OverstreetJuly 23, 2013 at 10:08 AM

    I use the UP! or Afinia 3d printer. It is the best printer for ABS right now.

    ReplyDelete

Subscribe to: Post Comments (Atom)